Peco Plan 2: BR Branch Line Build

This weekend I started a new project - whilst I try to sell my TT:120 layout - I wanted to build something simple in N gauge with a bit a operational play value. Whilst browsing some track plan books, I came across this Peco plan that briefly appeared and then disappeared from their track plan books - 

Total size is 2.5ft x 2.5ft so easily storable and fits on the dining room table. Rolling stock requirements are modest - a tank engine and a passenger coach with a few wagons would be enough. You could alter eras by swapping out with a Class 22 and DMU.

I'll compile a separate entry with my rolling stock for this layout but for now it was a case of getting started with the baseboard construction. After building my DCC plank, I though foamboard was the way to go with this as well considering it's relatively small size. 

After cutting to size, the pieces were glued in place with tacky PVA held in place with masking tape until dried. This results in a solid construction when dried whilst still remaining extremely lightweight. I gave my board a height of 4cm which should be sufficient for the Peco point motors I will be using.

That's all for now.