Peco Plan 2: BR Branch Line - Ballasting

Time to start ballasting!

I start a bit last weekend with a the two sidings, trying out the DCC Concepts Legacy N gauge ballast to see how it looked. I did a bit using the light grey blend and adding in some dark grey blend at the ends of the sidings (where coal wagons etc would stand for long periods, and just general accumulation of dirt and less activity to remove it).

Next I'll show the process of how I ballast, using the runaround section in front of the station.

First step is to dish out some ballast in the area you want to work using a teaspoon or similar utensil. I then use a medium (4) brush and work the ballast into the area, tidying up the inevitable strays that accumulate.

The above shows the effect achieved, the with the shoulder to the left still to be done.

The above is after all the ballast has been laid dry, with a tiny bit of the dark grey blend in and around the magnet (assuming this is where steam locos may have stood for periods).

Finally, the above shows after applying the PVA mix. I use a small spray bottle with water first to wet the ballast (from a suitable distance to avoid disturbing it too much!), and then I apply a 50/50 mix of PVA and water with a drop of washing up liquid using a large syringe. Then leave for 24-48 hours to set. 

The final task before trains can run again is to hoover up any loose bits, or apply more ballast if there are gaps where it's missing, and then clean the rail tops which would've been covered in some of the PVA mix.

I'm hoping this weekend I can get the rest of the layout done, or at least all the sections of track between points which take a bit more patience to ensure no ballast gets between the mechanism. 

A tale of track and ballasting...

 I've been experimenting with track painting and ballast this week.

I don't want a uniform look to my layout, as like the real thing, track colour and ballast varies over time as bits get replaced. To that end my approach is to take my time and complete the track painting and ballast in stages.

I purchased three types of ballast from Hornby - grey, grey basaltic, and limestone. I also purchased 3 railmatch paints - sleeper grime, dark rust and light rust.

These are the results:

The limestone and grey basaltic on their own are clearly overscale for TT 120. The grey on it's own looks... odd? I'm not sure why it looks so rounded.

I then decided to mix all all three:

Hmm, not sure! 

Moving onto a stretch of Hornby track (since that's what my roundy round layout uses) and I tried a mix of just the grey and grey basaltic rock. I also tried two different mixes for the rail sides; starting with a few drops of water I added all three paints for one half and then just the two rust colours for the other half.

Much better I think! I intend to use the mix of just rust colours for the sidings and less used sections of track. I'll also use the three types of ballasts in different areas of my layout, perhaps with some chinchilla sand or finer grey ballast added to improve the overscale look. The limestone for example can be used nearer the tunnel mouths with a transition to the grey/basaltic mix, and in areas like the engine shed I can just use the basaltic rock which dries darker. A black/grey wash with some coal deposits should help set the scene.

But first, I need to paint all of the track!